Conveyor

 

You should be clear about this — all sorts of attractions are available to the fpc2 conveyor, but there is actually a practical limit.

Although this is usually a tray, occasionally the slide is also happening. Now, let’s look at a number of factors.

Small units, such as the small individual corrugated box, especially when the post stack, would be vulnerable to the inherent instability, often is the roller spacing, and even more loose interlock stack or larger single units. This is more challenging for the slide board, but even the front edge of the tray is undulating, which generally fluctuate with the width, direction and position of the floor.

Generally speaking, when the tray bottom plate is running perpendicular to the cylinder (for example, parallel flow), it will be stable and easy to transmit. In contrast, if the board and the roller are parallel, it is important that the spacing between the boards and the roller is the distance between the roller.

However, the real brain teaser is to transfer money, especially when considering pallet types, loading and unloading directions and locations.

Tray two-way entry, for example, in one direction load, fpc3 conveyor, repositioning (such as 90 degrees Celsius), and then from different directions to uninstall, roller spacing is affected not only, even can meet the requirements for loading and unloading of directional requirement orientation, may constraint complex plant area. In other words, the substrate is the pallet, which is not only a factor of normal delivery, but also an important factor in handling, handling and handling.

As we all know, these are the most common omissions… Experience tells us that we also need to manage more details – many seemingly minor details can have a huge practical impact in installation and debugging.

That is why the industry depends on application surveys. Of course, they are tedious. Normally, we can see that the information doesn’t seem to be relevant, but it’s difficult to collect.

However, there are reasons for all these problems, and often these are based on a hard lesson.

 

 

Conveyor

 

The specifications of fpc1 conveyor are often ignored.

The problem is not just how much.

The first question… Usually, weight is the last question people ask about pallet transportation. In fact, we can see that this is an important issue, but not most of the planned trips.

We have thousands of high speed automatic pallet packaging project application research reviewed, as well as in the incomplete and incorrect data, complexity has been produced, five is sometimes ignore the specification details have been we identified. They include:

The first one is the width and the weight, the second is the lifting of the third detail is the speed of the existing conveyor belt, and the fourth detail is the pressure of the gravity conveyor belt. What is the substrate? It is usually a pallet configuration and direction.

Let’s take these apart, which is probably the least common.

In terms of width and weight.

The fpc1 conveyor has a specific specification, and in general, the standard range of 4-5000 pounds is its maximum weight. The calculation of this weight is calculated according to the typical pallet width. However, it is now tricky because, in general, the maximum load capacity is reduced as the effective width increases.

Altitude.

It is very important to pass the height and transfer, but it can be completely different for the emissions of the tray.

On the one hand, this is not a very big deal. It is also possible to specify the height of the conveyor’s legs. Besides when you arrived the stretch wrapper, through the process of height, height and load the cumulative impact of clearance delivery system such as the film up to a high enough, but it may make the machine in the aspect of structure become impractical, or may also occur in the facilities more than ceiling height.