If you want to avoid the first question of fpc1, what should you do?
As we all know, in 1972, L invented fpc1, in terms of technology, has greatly improved, the shipper to get the help, to send their goods from their device to their clients, damage is greatly reduced, and it also can be finished at the lowest cost.
However, we should also know that stretching is not without problems. Film damage is the biggest problem. That’s when something bad happens. In the best of circumstances, time and money will be wasted, to buy your product, but you will end up with disastrous results, with damaged goods the worst.
So, what’s the good news? You can limit the risk of breakage for the most common cause before stretching or even getting started. Here are some things you can do:
Your products are hung on a tray and can be prevented by you, and sharp corners can be eliminated. If you used to have a garbage bag at home, if someone had put a sharp corner box in it, then you’d know… This will produce a messy result
Proper handling of film is training operators. One of the main causes of the film rupture is due to improper film threading. In addition, if we discard a roll of film, or mishandled the film, the nicks will appear. The nicks took place on film breaks. Buying “cheap” film is undesirable because we can see that it has a higher risk of defects (gels, nicks, tears). If it’s a “cheap” film, it’s likely to produce less tear-jerking results, and the ability to extend it to the performance film isn’t there. Any savings you are achieving can disappear with a broken load that is what you think.
It’s not advisable to set the packing pressure too high. This process is a trial and error process, but it is worth the effort.