As we can see, there are three ways to avoid stretching.
We know that film destruction is more than just a stimulus. Unless they are damaged reasons can be found, and it also can be repaired, otherwise these be broken film can produce a series of problems, these problems are very unpleasant, we also call it as “circle” of the end.
A very bad place is the end of the world. So, when you start to break up, there’s one thing you should be aware of:
First, work on this film
A. does it fit properly?
B. This film, should you use it?
C. It is also defective, such as gel, crack, tear, etc. Is it defective?
Second, about its load and pallet.
It loads a tray. Do they have sharp corners or bumps? This question also needs to be considered.
Third, what is fpc2 stretch wrappers?
A: do you know that the wrap force set is correct?
B. Can you see if there is any indentation or resin accumulation on the surface of the membrane?
C. Film clip, what is a membrane clip, it is a fully automatic stretching wrapper.
I. What is the S clip: on the surface of the film, do you see any nicks or resin piles?
What is the vacuum clamp: is it the right air pressure? This air filter is it clean?
You should know that if these problems haven’t been exposed, you should need some help. You can call your favorite service technician, ask him or her to find your problem, and then help you solve the problem.
Is it ok if we look for other ways to improve? If you want to check us, you need a 10-step process, and if you want to reduce the damage, you need to do it through more effective stretch wrapping. Below, you can take a look at our process, and our process will show you a lot of things:
If you want to reduce shipping losses by 50%, what you should do! What is the key element of stretching packaging standard? The containment force should be managed, it is the mostcritical component of stretching.